Waxing a snowboard is one of the most important things you can do to improve your performance and protect your investment. Without the proper growth, the base can dry out your board and cause poor performance. Here is a simple proven method for snowboard waxes.
First you need to get a wax iron. While all the work of old iron, iron is the best to get cheap iron, which has no holes in the bottom. Special machines snowboard iron, butsupply cheap clothes are more expensive than iron and the same results. Iron waxing is better than other methods of applying wax, because it causes the wax to penetrate into the base of your snowboard and last longer.
Next you need to get some snowboard wax. For most snowboarders, is the best wax to use the wax for the whole season. A good choice is zoom-lens Dominator wax. If snowboarding is particularly dirty, you may need to buy some 'wax that is made specifically forCleaning, and perhaps even some citrus solvent. For the simple application of wax to wax the whole season is the way to go.
In order to iron the wax, you close the iron and prepare them for a average room, while the positioning of your snowboard. While snowboarding special media are available two chairs and a table will work for the application of wax in order. Note that the melted wax can drain the portion of the snowboard, please direct snowboarding within an acceptable range that is easy to clean.
Wheneverything is set, remove the block of wax season you get, and easy to press him on the hot iron on it hung above the base of the snowboard. Let the wax drip drops of snowboard wax from the tip to the end. You do not need to use an excessive amount of wax will work 20-30 drops per square meter basis.
When the drops of wax on your base is, it's time to start, board. Imagine creating the smelting of iron at the base and the droplets of a liquid waxSurface of the snowboard. Be sure to keep the iron moving at all times and make sure it is not high enough to burn the wax a cornice. Err on the side with the iron to a lower value. When you move the iron, make sure he touched every inch of ground. It is advisable to work towards the tip of the tail, preferably the iron is moved longitudinally.
As iron is a good idea to heat the basis for a warm temperature. This will help absorb more waxpossible. To check whether you're heating up the base enough to put your hand on the cover of the tabs. If it is hot, then you know you have warmed up the base enough.
If the wax is evenly distributed on your base, allow to cool. Once it is cooler, you can remove the excess and you're done! If you are at the end of the season, do not hesitate to remove the excess wax on the base and all sit on the board to get for next season.
0 comments:
Post a Comment